gulliver cot bed ikea Gulliver cot bed ikea

Children Cribs 6 Comments 0 We bought a Ikea Gulliver baby crib and some improvements needed to be made.

  • cot bed waterproof sheet john lewis
  • cot bed duvet bundle
  • cot bed 100 cotton duvet cover
  • We wanted to have the baby on same level as our own bed and without one side. This gave easy access towards the baby during the night. However there was a warning label that prevented that configuration. Reason why this configuration was not allowed was the fact that ends of the bed were not secured well enough to hold the base in place.

    gulliver cot bed ikea Gulliver cot bed ikea

    That was easy task to solve with couple of zip ties and one nylock nut. Warning label Securing bottom of the bed to the ends. The bolt for the pin was long enough to fit additional nyloc nut to the end and this way it was possible to create good place for the zip tie.

    gulliver cot bed ikea Gulliver cot bed ikea

    Instead of nyloc nut, a butterfly nut could be used. If you do not trust to zip ties and you are willing to make additional holes then a L-bracket could be used to secure the ends This is the outcome and this is how the bed was used couple of months before the baby learned how to roll. Then there was a risk that the baby would roll between the beds and fall to the floor. For an engineer that was just one more challenge.

    Crib on the same level as our bed and without one side The solution for this problem was to secure the beds together.

    sleigh cot bed set

    I did not want to fix the beds together, but also allow an access between the beds if one want to sit on the bed next to the baby. This was possible with a cabin hooks and extended bolts to the crib. The cabin hooks were screwed under the bed so that you could just fit the hook to the baby crib bolt. Cabin hooks were screwed under the bed.

  • argos silentnight cot bed duvet
  • cot bed pillow uk
  • cot bed toddler bed same size
  • Tip of the hook was slightly bend inwards. The original bolt was replaced with a threaded rod, a washer plate, a normal nut and an allen head sleeve nut. The normal nut is not really needed, but I found pre-cut threaded rods that were bit too long. I did not want to cut those shorter so I just added one nut.

    The replacement bolt and the original bolt. With this setup the crib was easy to secure to our bed, but it also gave an easy access between the beds. The other cabin hook was secured to the bolt with the rubber band, so it stayed in place when the crib was pivoted.

    It was just enough to open the hook from the one side.

    Mrs Carlin, from Mansfield, Notts, said: This is how we used the crib for first 6 months and when the baby started to crawl the bed base was lowered, but one side was still off for one month. We wanted to have the baby on same level as our own bed and without one side.

    Easy access between the bed and crib. This is how we used the crib for first 6 months and when the baby started to crawl the bed base was lowered, but one side was still off for one month. Do not modify or attempt this hack unless you know how to ensure its continued safety.

  • cot bed sale john lewis
  • cheap white sleigh cot bed
  • star cot bed bedding sets
  • Comment

    Samuro

    at 10:22

    It seems remarkable idea to me is

    Zolom

    at 15:59

    I think, that you are mistaken. I can defend the position. Write to me in PM, we will talk.

    Tele

    at 22:05

    Thanks for the help in this question, can, I too can help you something?

    Nijora

    at 21:32

    I can suggest to visit to you a site, with a large quantity of articles on a theme interesting you.

    Leave a Comment